File: AT30026C.EXE (Self extracting ZIP File) Date Created: July 17, 2002 Contents: README.TXT - This text file DCXAT300_PM1_26C.HEX - DCX-AT300 Firware Update: Version PM1 Revision 2.6c DCXAT300_PM1_26C.TXT - Revision history for all firmware updates to 2.6c DCXAT300_PM1_26C.FLASH - File used by Flash Wizard to update firmware FLASHAPP.TXT - Application note describing how to perform low level firmware update FLASH.BAT - DOS batch file that performs low level firmware update (requires setting board jumpers) AT1BOOT.EXE - Low level firmware update utility BOOTAT1.HEX - Boot loader code used by AT1BOOT.EXE Abstract: The files in this self-extracing ZIP file can be used to upgrade the firmware on a DCX-AT300 motion controller. Download the file and run it under a DOS prompt to extract the compressed files. If the DCX-AT300 already has firmware revision 1.3a or later installed, the Flash Wizard can be used to upgrade the firmware on the controller. The Flash Wizard is a program that can be run under Windows 95, 98 or NT. You can download the Flash Wizard, form the support area of Precision MicroControl's Web site at www.pmccorp.com. To determine what revision of firmware is installed in a DCX_AT300, run the WINCONTROL program under Windows, or the DCX2CTRL program under DOS, and type VE at the prompt. The controller will display the currently installed firmware revision number. If the existing firmware is older than 1.3a, or the update process fails, the included text file FLASHAPP.TXT describes how to perform a lower level update using FLASH.BAT. Note that this firmware requires that the DCX-AT300 motherboard have 1 megabyte of flash memory installed. The amount of memory installed on the board will be reported by the VE command. If the motherboard does not have sufficient memory, contact the factory for assistance. The text file DCXAT300_PM1_xxx.TXT contains a complete revision history for all firmware updates. If you have any difficulty using these files, please contact PMC technical support at: support@pmccorp.com or Tel: (760)930-0101 FAX: (760)930-0222 Copyright Precision MicroControl Corp. 1998-2002 All rights reserved